About the PAX A920Pro Terminal
Power On/Off
Power ON: Press and hold the power button down for 3 to 5 seconds and then release.
Power OFF: Press and hold the power button down for 3 to 5 seconds and then release.
Charging Port
The USB Type-C charging port is located along the left side of the terminal
WIFI Connection:
Open the Settings app.
Enter Password: pax9876@@
Select WIFI.
Select your SSID.
Enter your WIFI Password, Press Connect.
SIM Installation:
Remove the back cover.
Gently remove the battery from the device.
Insert the card into the SIM1 slot as directed by the diagram.
Replace the battery and back cover.
Power On the device.
Open the Settings app.
Enter Password: pax9876@@
Select Mobile Network.
Select Advanced.
Select Access Point Names.
Select Telus - Jasper by pressing the circle on the right side of the screen.
Paper Installation:
Open the paper compartment by lifting the printer hatch release.
Insert a roll of paper as directed in the below image, ensure there is excess paper fed over the cutter.
Close the paper hatch until it clicks
Firmly pull the paper at an upwards angle to tear the excess paper
Front View:
Rear View:
Side View:
About the PAX A920Pro Charging Base
Installation Instructions:
Use the Type-C USB cable to connect the base’s Type-C USB power port with the power adapter.
Align & Embed the connected USB cable in the channel guides according to the outlet direction on the base’s bottom, and place the base on a stable flat surface.
Place the A920Pro Terminal on the base and verify there is a lightning bolt displayed on the battery icon.
Top View:
Back View:
Side View:
